StudyBrio

Concentration & dilution lab

Concentration1mol/L
Solution volume0.5L
Dissolved solute0.5mol
Excess solid0mol
Initial state00.511.52Lc = 1 mol/LV=0.5 L; n=0.5 molCurrent state00.511.52Lc = 1 mol/LV=0.5 L; n=0.5 mol→
Unsaturatedc = n(dissolved) / V

Blue markers show dissolved solute; brown squares show excess solid. Colours and markers are schematic.

Experiment log

ActionV (L)n (total, mol)n (solid, mol)c (mol/L)
Initial state0.50.501
Save, share & print

Compare adding water, draining and evaporation

Molarity is dissolved moles divided by solution volume in litres. Adding water can dilute an unsaturated solution. Draining a well-mixed solution removes solvent and dissolved solute in the same proportion, so its concentration is unchanged immediately after draining. Evaporation removes only solvent in this model.

At the chosen solubility limit, extra solute remains as solid. Adding water may dissolve that solid before concentration falls. Draining a saturated solution leaves the settled solid unchanged. Use c1 V1 = c2 V2 only while dissolved moles remain constant.

The model assumes instant mixing and equilibrium, additive volume changes, negligible volume change from solute, and nonvolatile solute. Settled solid is not drained. Temperature, ion dissociation, heat transfer and mixing-volume changes are omitted. Marker counts are rounded and capped; readouts supply the calculated amounts.

OpenStax: molarity and dilution